More progress was made and I am BEAT.

After making a template, I cut out some aluminum stock (in the den... AGAIN.) Sorry boo.


The base of the seatback had a roll to it so I clamped a piece of PVC tube to the table and rolled it a lil. Keep in mind, I have no idea what the fuck I'm doing here so it was just my dumb luck that it worked out PERFECTLY and is beyond me haha...


Duct taped it to the seat base.


Made a lil tool


And marked off where the rivets would go


That's gonna be a loooot of holes


After a few hours of drilling and riveting, I had a nice finished product.


I prepped the backs for a lil patina treatment (will show ya manana) and got to trimming the unneeded fabric frames to clean up the bases with the manliest tool evar; the angle grinder w00t ;)




More updates tomorrow, I'm going to bed.

This entry was posted by JKREW, on Wednesday, July 30, 2008. You can leave your response.